Laboratory Magnetic separator
XCRS is mainly used for laboratory for metallic mineral processing. It leads at
the same time, the magnetic separation of the fine-grained ores with strong
magnetism by the use of wet- method. It is a small volume, light in weight,
easy in operation and maintenance convenient. However, it is not suitable to be
used with corrosive alkalis trials in preparation. The product is indicated by
the only company of the former Ministry of Geology and Mineral Resources,
manufactured in accordance with industry standards.
Drum Magnetic
Separator is with an open magnetic system in its rotary drum quickly separate
magnetic minerals absorbed by the magnetic force on the surface of the drum and
threw mud in motion by a magnetic force, before it is washed out of the separator
with the provided means of the rotation of the drum surface.
XCQS wet
magnetic separator is composed of two parts, the main body power supply and the
drum. The main part of Magnettrennumfasst essentially: (1) frame (2) magnetic
drum ( 3) ore tank (4) spray tube ( 5) transmission ( 6) feed tank.
The drum power
supply has a separate silicon bridge rectifier Targeted voltage source whose
output is adjusted by the handle of the voltage regulator.
First Frame: The
frame is welded by angle iron. It is the supporting part of the whole Gold
Mining Machine.
Second Magnetic
drum: four excitation coils and magnetic cores within the magnetic drum
installed. In addition, an inter- pole without exciting coil on the side of the
magnetic drum is installed along which the ore is discharged in order to
facilitate the discharge of ore. These form a sector and fastened on the
mandrel. The mandrel is mounted on the frame by bearing bush. The drum is made
of a nonmagnetic aluminum and stainless steel. The combination of sector coil
causes the alternation of the magnetic field polarity at each magnetic pole
palm. The grains of ore rotate 180 ° each time a magnetic pole goes. Under the
action of the magnetic stirring, the quality of the magnetic products can be
improved. At one end of the mandrel is square extension structure that can be
pulled by hand to rotate the magnetic poles axially in the magnetic drum,
causing it to meet the requirements for the sorting of different types of ore.
3rd Transfer
device: The transfer device is installed on one side of the bottom of the frame.
In order to lower the center of gravity of the machine, the transmission part
of three-phase AC motor, worm gear and worm gear is there. The output of the
transmission is transferred to the magnetic drum by chains to ( not rotate the
magnetic pole ), the rotation of the magnetic drum to drive. The magnetic drum
is rotated at a constant speed of 25 rev / min. The direction of rotary force
of the magnetic drum is consistent with the direction of ore feeding.
4th food
container
The feed tank is
welded through aluminum and stainless steel plate. It is attached to the frame
with screws. An overflow mouth to keep the liquid level is lined on the side of
the feed container, along the ores are set. Concentrate feeding mouth can be
received at the bottom of the concentrate discharge tank ores.
5th spray tube
A copper pipe
with hole installed on the frame is connected to the indoor water source and is
used to wash the concentrate on the magnetic drum. The spray angle can be
adjusted by the rotation of the spray pipe.
6th Ore field
7th Feed Tank
The feed tank is
welded by stainless steel plate which is used to ensure the homogeneity during
material feeding.
没有评论:
发表评论